Blog · October 14, 2026 · North Carolina
The Stokes County Flood Zone Map: a North Carolina guide
Look up any Stokes County address on FEMA's flood map, read the zone, and match it to the parcel record for land around Tobaccoville.
Main page: Stokes County, NC GIS & Parcel Viewer (official map link, Stokes County facts and neighboring maps).
Platbookmapper is an Amazon Associate. If you buy through an Amazon link on this page, we earn a commission. The link is a product, not the county map.
Land along Belews Lake and the flats outside Walnut Cove are where a Stokes County flood zone map lookup matters most. For any tract in Stokes County, North Carolina, the answer affects insurance, permits and resale.
We'll cover finding a Stokes County address on FEMA's map, what Zone A, AE and X mean, how the county viewer fits in, and what to do if the map looks wrong.
How to use the Stokes County flood zone map
FEMA's official flood maps for Stokes County are free at the FEMA Flood Map Service Center. Search returns the effective FIRM panel for the spot in Stokes County, plus any pending changes FEMA has posted. For an irregular lot near Walnut Cove, try FEMA's National Flood Hazard Layer viewer; zoom to the tract around Walnut Cove and click. Switch to the Stokes County parcel viewer and track down the same tract around Walnut Cove. If the Stokes County viewer has a floodplain layer, treat it as a convenience copy and confirm on FEMA's map.
The county map you'll pair it with
Stokes County publishes its parcels on the Stokes County parcel viewer, free to use for a lot in Tobaccoville or a tract around Stokesdale. Use the search box for an address in Tobaccoville or a parcel number, or simply zoom in and click a tract around Stokesdale. Our Stokes County, NC page keeps the official link and the maps next door to Stokesdale in one place.
Neighboring maps around Stokes County
Near the edge of the county, check the next map over: Forsyth County, Guilford County, Rockingham County, Surry County, and Henry County, VA all border it. Every map bordering Stokes County is listed on our North Carolina directory.
Zone A, AE and X in plain English
Any Stokes County parcel shaded as Zone A, AE, AH or AO sits in what FEMA calls a Special Flood Hazard Area, defined by a 1-percent annual chance of being flooded. Where a Stokes County tract shows Zone AE, there's a base flood elevation to compare a building against; in Zone A there isn't one. If a Stokes County parcel shows shaded Zone X, it is moderate risk, between the 1-percent and 0.2-percent annual chance lines. Unshaded X (or C) on the Stokes County panel means minimal risk.
Creeks, rivers and low ground in Stokes County
Parcels touching Belews Lake deserve a FEMA check before anything else in Stokes County. Don't assume a tract around Walnut Cove is clear because its road frontage sits high. Small streams and ditches near Danbury may not be studied in detail can still flood; FEMA says moderate- and low-risk areas still carry risk.
Stokes County at a glance
From Danbury, the seat of the county, the map spreads out to King, Walnut Cove, Stokesdale, and Tobaccoville. Smaller places such as Germanton, Pinnacle, and Aarons Corner appear on the Stokes County map as little clusters of lots. Roughly 449 square miles of land and about 45,532 residents (2023 estimate) make up Stokes County. The Stokes County map mixes subdivision lots near Danbury with farm and wooded tracts farther out.
Insurance, permits and map changes
Insurance is the practical stake for a Stokes County buyer. Where a building in Danbury falls inside an A or V zone and secures a loan from a federally regulated or insured lender, a flood policy becomes a loan condition; that applies where the local government around Walnut Cove is in the National Flood Insurance Program. For a Stokes County home in shaded or unshaded X, federal rules do not require a policy, although some lenders require it anyway. Where a structure near Danbury looks higher than the shading suggests, the titleholder can ask FEMA for a Letter of Map Amendment (LOMA), supported by elevation data from a licensed land surveyor. Placing fill on low ground near Danbury commonly requires a permit and an elevation check; the county floodplain administrator can say what applies.
Recorded documents in Stokes County, North Carolina
For a tract around Stokesdale, the recorded documents sit with the Register of Deeds; the parcel map is built from them for taxes. For a lot near Danbury, the recorded plat and deed are with the Stokes County Register of Deeds. Copy the parcel ID and legal description from the county record before you request a deed for land near Danbury.
Quick answers for Stokes County
My house near King is in Zone X. Is insurance required?
FEMA does not require it for a Zone X lot in Tobaccoville, but coverage is available and some lenders ask for it.
Is my Tobaccoville address in a flood zone?
Look it up at FEMA's Flood Map Service Center, then match the parcel lines in the county parcel viewer; for land near King, a zone starting with A or V is high risk.
What is a base flood elevation for a Stokes County property?
On the map covering Tobaccoville, it's the projected water surface in the base flood; elevation certificates in Stokes County are measured against it.
What does Zone AE mean on a Stokes County flood map?
For a Stokes County parcel, Zone AE means a Special Flood Hazard Area with a 1-percent annual chance of flooding and a published base flood elevation.
What if FEMA's map is wrong about my house near King?
FEMA reviews requests such as a LOMA for Stokes County properties; start with an elevation certificate.
Open the official Stokes County, NC parcel map Stokes County in the Platbookmapper directory
Not a survey. County GIS and tax parcel maps are assessment and planning layers. They are not a substitute for a recorded plat, deed, or licensed survey, especially for fences, setbacks, or boundary disputes.